General Update
Focusing on software for this few weeks
Jig is basically functional
Some refinements are needed (e.g. No jumper wires, Interface, Veroboard)
Will start progress report and design specification report soon.
More investigation into propagation delay needed (Need wait for parts to arrive)
Using ethernet cable with different length
BiSS - Software
Trying to Calculate RPM using DMC Speed block, not having much luck on it. Had a sesh with Ary and Chi on Friday (16Oct) also can't pin point the issue.
Manual RPM Calc → Link
Error counter
At 8MHz with motor running(10k RPM), errors could be observed with a BER of ~2%. Lowering the frequency to 4MHz eliminate the Bit Error. When motor is not running there's only 1 error in 4mins at 8MHz. (More investigation has to be done)
Jig Update
A sticker is added so that the RPM counter could observe the reflection of the surface to calculate the RPM
Timeline
